Pilot Debrief

FLIGHT DESIGN GMBH CTLS near Conway, AR — 2012-07-25

Final reportCEN12LA476
Sign in to save
Date
2012-07-25
Location
Conway, AR, USA
Airport
CWS
Aircraft
FLIGHT DESIGN GMBH CTLS
Registration
N930SA
Category
Airplane
Highest injury
None
Fatalities
0
Phase of flight
Landing

Probable cause

The pilot's improper landing flare, which resulted in a hard landing and overstress failure of the right main landing gear.

NTSB narrative

The pilot reported that after completing an uneventful straight-in approach, the right main landing gear collapsed upon touchdown. The airplane subsequently swerved to the right, departing off the right side of the runway. A laboratory examination revealed a longitudinal crack along the leading edge of the right landing gear leg and a transverse fracture near the point where the leg intersected the fuselage. Observed fiber pullout and parallel transverse cracks in the paint adjacent to the fracture were consistent with a bending load, with the lower surface in tension and the upper surface in compression. No preexisting damage or manufacturing anomalies were noted with the right main landing gear that would have reduced its design strength. The lack of any observed material defects or preexisting damage suggests that the right main landing gear fractured when it experienced a bending load that exceeded its design requirements, likely during the accident sequence.

Analysis

Primary failure mode
Mechanical failure
First missed decision gate
Inspect landing gear for cracks before flight to prevent failure on landing.

NTSB coding

Evidence available

  • Photos
  • 4 docket documents
View NTSB final reportView NTSB docket

Docket documents4

Related mishaps