Pilot Debrief

Cessna 180 near Cut Bank, MT — 2018-07-09

Final reportGAA18CA404
Sign in to save
Date
2018-07-09
Location
Cut Bank, MT, USA
Airport
CTB
Aircraft
Cessna 180
Registration
N180GB
Category
Airplane
Highest injury
None
Fatalities
0
Phase of flight
Landing

Probable cause

The pilot's failure to maintain directional control during the landing roll.

NTSB narrative

According to the pilot in the tailwheel-equipped airplane, he circled the airport to check the wind direction and speed and then he initiated a final approach about 70 knots with 3 notches of flaps. He reported that the airplane encountered a wind gust before he initiated the landing flare. Upon touchdown, the airplane bounced, and he applied forward yoke pressure. The airplane began to drift right of the runway centerline during the landing roll, and he applied left rudder and left aileron to counter the drift, but when the tailwheel touched down, the airplane veered left. He applied right rudder and right brake, but the right main landing gear collapsed, the left wing lifted, and the right wing struck the ground. The airplane exited the left side of the runway, and it came to rest in the grass safety area. The airplane sustained substantial damage to right wing spar. The pilot reported that, about the time of the accident, the wind was about 7 knots from the west-southwest. The pilot landed the airplane on runway 32. The METAR at the airport reported that, about the time of the accident, the wind was calm and the skies were clear. The pilot reported that there were no mechanical malfunctions or failures with the airplane that would have precluded normal operation.

Analysis

Primary failure mode
Loss of control
First missed decision gate
Pilot could have aborted landing after bounce to prevent loss of control.

NTSB coding

Evidence available

  • Photos
  • 2 docket documents
View NTSB final reportView NTSB docket

Docket documents2

Related mishaps