Cessna 172M near San Diego, CA — 2008-06-24

Probable cause

The student pilot's failure to maintain directional control during a touch-and-go landing.

NTSB narrative

The student pilot reported that he was practicing touch-and-go landings and made a normal landing on runway 28L. Witnesses located adjacent to the runway observed the landing, and stated that the airplane landed hard on the right main landing gear. During the landing roll, the pilot raised the flaps, turned the carburetor heat off, and started to increase engine power when the airplane then began to veer to the left. He then applied full engine power in an attempt to get the airplane airborne. The airplane became airborne and the left main landing gear struck a taxiway sign. The pilot then elected to abort the takeoff and he reduced engine power, switched off the master switch and turned off the magnetos. The airplane continued into the adjacent ramp area and struck a parked and unoccupied helicopter.

NTSB coding

• Loss of control on ground · Landing-landing roll

Related mishaps

• CESSNA A185F

  2026-06-27 · Angel Fire, NM

• CESSNA 180H

  2026-06-21 · Port Angeles, WA

• CESSNA 140

  2026-06-01 · Pasco, WA

• EAA Acro Sport II

  2026-05-31 · Sheridan, AR

• PITTS SPECIAL S-1S

  2026-05-29 · Bartlesville, OK

• GULFSTREAM AEROSPACE CORP GVII-G600

  2026-05-27 · Birmingham, AL