Pilot Debrief

BEECH D95A near Hitchcock, TX — 2016-10-04

Final reportCEN17FA005
Sign in to save
Date
2016-10-04
Location
Hitchcock, TX, USA
Aircraft
BEECH D95A
Registration
N76S
Category
Airplane
Highest injury
Fatal
Fatalities
1
Phase of flight
Maneuvering

Probable cause

The flight instructor's loss of control during an aerodynamic stall demonstration, which resulted in an inadvertent spin from which he was unable to recover. Contributing to the accident was the flight instructor's lack of familiarity with the airplane's stall characteristics.

Contributing factors

Contributing to the accident was the flight instructor's lack of familiarity with the airplane's stall characteristics.

NTSB narrative

A flight instructor and private pilot receiving instruction departed on the accident flight to practice aerodynamic stalls in the multiengine airplane. After the accident, the pilot recalled that the instructor initiated an aerodynamic stall maneuver about 4,000 ft mean sea level, then recalled the instructor "cursing" the airplane when it would not recover from the stall. The pilot could not recall any further details of the accident flight. A witness about one 1 mile south of the accident site saw the airplane descending in a fully- developed right spin. Data retrieved from an onboard GPS unit revealed that the airplane entered a climb from about 4,000 ft, reaching a peak altitude of about 4,800 ft. The airplane then immediately entered a descent that continued until the end of the recorded data. Post-accident examination of the airplane revealed no mechanical malfunctions or anomalies that would have precluded normal operation. Review of the flight instructor's logbooks indicated that he had accumulated over 9,800 total hours of flight experience, with over 4,600 hours in multiengine airplanes; however, he had only accumulated 16 hours in the 11 years before the accident. He had logged about 11 hours in the accident airplane, of which about 6 hours were as a flight instructor, all within the previous two months. His logbooks did not indicate that he had previously practiced aerodynamic stalls in the accident airplane; therefore, he was likely unfamiliar with the airplane's stall characteristics. Following a series of fatal accidents in Beech Baron/Travel Air airplanes between 1978 and 1980, the National Transportation Safety Board issued safety recommendations to the Federal Aviation Administration, stating that these airplanes have a propensity for entering flat spins under high asymmetric power and low speed conditions; such conditions are frequently encountered during multiengine emergency (engine-out) training. It is likely that, while demonstrating aerodynamic stalls, the airplane entered a spin from which the flight instructor was unable to recover.

Analysis

Primary failure mode
Loss of control
First missed decision gate
Instructor should have avoided stall maneuver in training.

NTSB coding

Evidence available

  • Video
  • Photos
  • 14 docket documents
View NTSB final reportView NTSB docket

Docket documents14

Related mishaps