PIPER PA 28 near Corona, CA — 2018-01-13

Probable cause

The student pilot and flight instructor’s failure to see and avoid powerlines during a simulated emergency landing, which resulted in a wire strike during a go-around.

NTSB narrative

According to the flight instructor, during an off-airport simulated engine failure with a 180° turn, he called for a go-around upon completion of the maneuver. The student initiated the go-around, but the airplane struck power line wires. The flight instructor landed the airplane in a field, and the nose landing gear separated from the airplane. The airplane sustained substantial damage to the engine mounts. The flight instructor reported that this accident could have been prevented by performing a ground reconnaissance of unfamiliar practice areas to assess for hazards to flight. The flight instructor will also initiate simulated engine failures at a higher altitude to enable recovery at no less than 500ft above ground level. The pilot reported that there were no preaccident mechanical malfunctions or failures with the airplane that would have precluded normal operation.

NTSB coding

• Simulated/training event · Maneuvering-low-alt flying
• Attention / Monitoring

Evidence available

• Photos
• 2 docket documents

Docket documents2

• Pilot/Operator Aircraft Accident Report, NTSB Form 6120.1form
• Photo (Courtesy of FAA)photos

Related mishaps

• PIPER PA 28

  2016-06-11 · Gilmer, TX