Pilot Debrief

WEBB WEBB 2 near Gainsville, TX — 2013-01-28

Final reportCEN13LA147
Sign in to save
Date
2013-01-28
Location
Gainsville, TX, USA
Airport
GLE
Aircraft
WEBB WEBB 2
Registration
N4844W
Category
Gyroplane
Highest injury
None
Fatalities
0
Phase of flight
Maneuvering

Probable cause

The pilot’s failure to follow his test plan and abort the takeoff after inadvertently lifting off during a high speed taxi test. Contributing to the accident was the pilot’s lack of flight experience in the gyroplane.

NTSB narrative

The pilot was performing initial high-speed taxi tests of his experimental amateur-built gyroplane when it inadvertently became airborne. The pilot then initiated a climb above the runway and continued to fly the airplane to return for landing on the departure runway, which was contrary to the test plan. He did not want to fly past the airport boundary nor any of the hangars on the southeast side of the runway, so he initiated a left turn to crosswind. The gyroplane lost altitude faster than the pilot anticipated and became "low, slow, and behind the power curve" at too low of an altitude to recover. The lower tailboom touched down in a hard landing, which deformed the rudder and tailboom. The rotor was damaged when it contacted the ground. The pilot stated that the accident could have been prevented if he had followed the test plan and landed that gyroplane when it first lifted off. The pilot also stated that a lack of experience in the make and model gyroplane contributed to the accident.

Analysis

Primary failure mode
Loss of control
First missed decision gate
Pilot should have landed when the gyrocraft first lifted off.

NTSB coding

Evidence available

  • 1 docket document
View NTSB final reportView NTSB docket

Docket documents1

Related mishaps