ROBINSON HELICOPTER R22 BETA near Dayton, NJ — 2011-07-20
- Date
- 2011-07-20
- Location
- Dayton, NJ, USA
- Aircraft
- ROBINSON HELICOPTER R22 BETA
- Registration
- N83509
- Category
- Helicopter
- Highest injury
- Serious
- Fatalities
- 0
- Phase of flight
- Maneuvering
Probable cause
The pilot's inadequate compensation for wind during an out-of-ground-effect hover, which resulted in a loss of control due to settling with power and loss of tail rotor effectiveness.
NTSB narrative
The pilot slowed the helicopter to an out-of-ground-effect hover at an altitude of 400 to 500 feet above ground level (agl) while performing a photography mission. The photographer asked for a different vantage point; as the pilot explained that wind and high power demands would prevent him from accommodating the request, the helicopter began to "settle with power." The pilot attempted to arrest the descent with a reduction of power and a forward cyclic input. As the pilot took the corrective action, the helicopter yawed to the right and began to rotate around the main rotor mast. He reduced the throttle to idle to arrest the spin, and the yaw rate slowed. However, the spin continued as the helicopter descended through about 250 feet agl. The pilot stated that the helicopter was still spinning when it struck the ground upright. Review of an audio recording from a video camera aboard the helicopter indicated that the low rotor rpm audio alarm was on during the final 7 seconds of the flight. A witness reported that the engine ran "fine" and "perfectly" all the way to ground contact. Examination of the wreckage revealed no evidence of pre-impact mechanical malfunctions or failures that would have precluded normal operation of the helicopter. The helicopter was operating in a high-power, low-airspeed condition that required the pilot to be especially aware of wind direction in order to avoid tailwinds, which can result in a loss of control due to settling with power and/or a loss of tail rotor effectiveness. Although the pilot’s comment to the photographer indicated that he was concerned about the wind angle, it is likely that he did not maintain a nose-into-the-wind position. When the helicopter began to settle with power, the rotor rpm dropped, and the tail rotor lost effectiveness. There was insufficient altitude for the pilot to affect a recovery before the helicopter impacted the ground.
Analysis
- Primary failure mode
- Loss of control
- First missed decision gate
- Pilot could have avoided maneuvering in high power, low airspeed conditions.
NTSB coding
Evidence available
- Photos
- 11 docket documents
Docket documents11
- Pilot/Operator Aircraft Accident Report, NTSB Form 6120.1form
- R22 Beta II Pilot Operating Handbook: Section 5 Performanceform
- R22 Performance Calculations & Chartsform
- Release of Aircraft Wreckage, NTSB Form 6120.15form
- Fuel Receiptsother
- Pilot Record of Conversation (FAA)other
- Weight and Balance Calculationother
- On Board Image Recorder 17 - Specialist's Factual Reportphotos
- Photo 1: Front of Wreckage (Courtesy of FAA)photos
- Photo 2: View of Helicopter Damage (Courtesy of FAA)photos
- Police Reportreport
Related mishaps
- ROBINSON HELICOPTER COMPANY R44 II
2014-06-18 · Coldfoot, AK
- BELL 206L-3
2013-06-28 · Missoula, MT
- SCHWEIZER 269C-1
2010-06-21 · Asheville, NC
- ENSTROM F-28C
2010-02-06 · Fort Pierce, FL
- EUROCOPTER AS-350 BA
2008-06-23 · Chickaloon, AK