GUISINGER GARY G BABY BELLE near Stuart, IA — 2015-09-12
- Date
- 2015-09-12
- Location
- Stuart, IA, USA
- Aircraft
- GUISINGER GARY G BABY BELLE
- Registration
- N135PA
- Category
- Helicopter
- Highest injury
- Minor
- Fatalities
- 0
- Phase of flight
- Maneuvering
Probable cause
The failure of the tail rotor driveshaft for reasons that could not be determined due to the mechanically and thermally deformed fracture surface.
NTSB narrative
The private pilot was conducting a personal flight in the experimental, amateur-built helicopter. The pilot reported that, while he was maneuvering the helicopter about 400 ft above ground level, it yawed left, then suddenly "snapped" right, and then began spinning. The pilot attempted to regain control of the helicopter and was able to briefly stop the spin, but the spin then continued. The pilot subsequently conducted a forced landing to a cornfield, during which the helicopter impacted terrain and rolled over. Examination of the helicopter revealed that the tail rotor driveshaft had failed during the flight, which resulted in a loss of control. The fracture surface of the driveshaft was mechanically and thermally deformed, and the failure mode could not be established. The pilot's medical and flight review were not current; however, the pilot's actions were not a contributing factor in the accident.
Analysis
- Primary failure mode
- Mechanical failure
- First missed decision gate
- Pilot could have addressed tail rotor issues during maintenance before the flight.
NTSB coding
Evidence available
- Photos
- 4 docket documents
Docket documents4
Related mishaps
- CESSNA R172E
2024-07-06 · Hillrose, CO
- PIPER PA-34-200
2023-05-03 · Coldspring, TX
- PIPER PA-14
2021-07-23 · Anchorage, AK
- SOPWITH Type 9400
2020-07-03 · Van Alstyne, TX
- Autogyro Cavalon
2018-10-30 · Sebring, FL · 2 fatalities
- Beech 35
2018-09-22 · Georgetown, SC