TAYLORCRAFT BC-65 near Madras, OR — 2010-12-01

Probable cause

The failure of both pilots to see and avoid the other airplane while in the traffic pattern to land, which resulted in a midair collision.

NTSB narrative

The propeller of a Taylorcraft airplane and the empennage of a Cessna airplane came in contact with each other while both aircraft were on final approach to the same runway. The pilot of the Cessna had completed a landing and performed a standard entry (left) onto the downwind leg of the traffic pattern. The pilot of the Taylorcraft was returning from a local area training flight and entered the downwind leg of the traffic pattern from a standard mid-field 45-degree entry. The Cessna pilot was announcing his position on the common traffic advisory frequency during each segment of the pattern; however, the pilot of the Taylorcraft could not hear the transmissions since his airplane was not equipped with a radio. Just prior to impact, the pilot of the Taylorcraft observed the empennage of the Cessna underneath the left wing of his airplane. The pilot of the Cessna never observed the Taylorcraft, but heard a loud bang come from the aft end of his airplane at impact. Both pilots were able to land their airplanes without further incident.

NTSB coding

• Midair collision · Approach-VFR pattern final
• Attention / Monitoring

Related mishaps

• PIPER PA28

  2024-12-09 · Pahokee, FL

• CESSNA 152

  2022-08-18 · Watsonville, CA · 3 fatalities

• CESSNA 172S

  2020-09-25 · San Marcos, TX

• Cessna A185

  2020-08-27 · Fairbanks, AK · 2 fatalities

• BEECH F33

  2016-09-07 · Carrollton, GA · 3 fatalities

• CESSNA 185

  2015-06-01 · Talkeetna, AK