Pilot Debrief

Luscombe 8 near New Carlisle, OH — 2018-08-31

Final reportCEN18LA362
Sign in to save
Date
2018-08-31
Location
New Carlisle, OH, USA
Airport
3OH0
Aircraft
Luscombe 8
Registration
N2305K
Category
Airplane
Highest injury
Serious
Fatalities
0
Phase of flight
Takeoff roll

Probable cause

A total loss of engine power shortly after takeoff due to carburetor ice.

NTSB narrative

The pilot reported that the airplane exhibited reduced climb performance during takeoff and that the engine began running rough when the airplane had climbed to about 150 ft above the ground. The pilot turned on the carburetor heat, but then removed carburetor heat when he perceived an increase in engine roughness. The engine subsequently lost total power and the pilot performed a forced landing, resulting in substantial damage to the forward fuselage and right wing. Examination of the airplane and engine did not reveal any evidence of mechanical malfunctions that would have precluded normal operation. Both fuel tanks contained fuel, the vented fuel caps were not obstructed, and there was uncontaminated fuel found in the carburetor fuel bowl. The weather conditions at the time of the accident were conducive to the formation of carburetor icing at a descent engine power setting. Although the pilot did not observe any evidence of carburetor ice when he verified function of the carburetor heat control before takeoff, given the lack of engine anomalies, the pilot's description of reduced climb performance and the rough-running engine was consistent with the accumulation of carburetor ice. The reported increase in engine roughness after carburetor heat was applied is further evidence of carburetor ice, but the pilot’s momentary application of carburetor heat would have been ineffective in removing the ice and restoring engine power. Additionally, the low altitude at which the loss of engine power occurred significantly reduced the amount of time available to the pilot to troubleshoot and restore engine power before the forced landing.

Analysis

Primary failure mode
Engine power loss
First missed decision gate
Pilot could have applied full carburetor heat immediately after engine roughness began.

NTSB coding

Evidence available

  • Photos
  • 9 docket documents
View NTSB final reportView NTSB docket

Docket documents9

Related mishaps