Pilot Debrief

VICTOR M CORDERO RV-9A near Apopka, FL — 2014-02-23

Final reportERA14LA130
Sign in to save
Date
2014-02-23
Location
Apopka, FL, USA
Airport
X04
Aircraft
VICTOR M CORDERO RV-9A
Registration
N19VC
Category
Airplane
Highest injury
Serious
Fatalities
0
Phase of flight
Approach

Probable cause

The failure of the propeller spline shaft, the drive disk adapter, and the propeller speed reduction unit (PSRU) input spline due to a lack of inspection and lubrication, which resulted in a total loss of propeller drive and a subsequent forced landing. Contributing to the accident was the lack of manufacturer guidance for inspecting and lubricating the PSRU gearbox spline components.

Contributing factors

Contributing to the accident was the lack of manufacturer guidance for inspecting and lubricating the PSRU gearbox spline components.

NTSB narrative

The pilot reported that, during the approach to landing, the airplane's propeller stopped spinning but that the engine continued functioning normally. He subsequently made a forced landing to a field. During the landing, the airplane flipped over and came to rest inverted, which resulted in substantial damage to the wings and vertical stabilizer. Postaccident examination of the engine revealed that the spline shaft had uncoupled from the drive disk adapter. The splines of the spline shaft, the drive disk adapter, and the propeller speed reduction unit (PSRU) input spline exhibited signs of severe wear consistent with fretting corrosion. Research revealed that several spline shaft failures had occurred on other airplanes; some of the failures resulted in a loss of engine power and subsequent forced landings, whereas some of the failures were identified during inspection. The manufacturer issued guidance to users to apply a nickel or copper antiseize compound on the spline shaft during installation of the PSRU to decrease wear; however, the manufacturer did not provide users with any instructions or recommendations to routinely inspect and lubricate the spline components. The pilot/builder reported that the PSRU and spline shaft had not been removed, lubricated, or inspected since it had been installed about 325 hours before the accident.

Analysis

Primary failure mode
Mechanical failure
First missed decision gate
Inspect and lubricate PSRU and spline components during maintenance.

NTSB coding

Evidence available

  • Photos
  • 14 docket documents
View NTSB final reportView NTSB docket

Docket documents14

Related mishaps